These, two piece, billet rear top hats help extend travel by 30mm to help prevent bottoming of the rear shocks. This allows the suspension to travel naturally when lowered wthout clunking or a harsh ride. Each set comes with 1 pair of rear top hats and included hardware.
These adapters adapter K series intakes to F22B and f23 Engines. Machined from Billet 6061, with advanced 3D port blending for optimal flow, these adapters include everything needed (minus gaskets) to swap a K series intake onto your engine. Not tested for rear transmission mount clearances. Specifically machined to match the larger f23 ports for best flow.
Convert your F22 to a newer, better flowing K series intake manifold. This high quality, 3D advanced machined Billet 6061 adapter comes with all the necessary hardware to bolt on a K series intake to your F/H seres cylinder head. It has a large .875" width for better 3D blending between port sizes. Will allow for K series stock Intakes, aftermarket intakes and ITBS. This plate will open up your F series to a whole new level of aftermarket parts from, Kinsler, Skunk, Eagle, AEM ect. Designed for a good stock upgrade to advanced boosted engines.
These bushings replace the stock bushings with Delrin machined bushings to eliminate slop and wiggle in the clutch and brake pedals. This wiggle causes premature failure of the clutch retainer, breaking the welds.
Each kit contains 2 bushings.
Standard / Manual Transmissions requires 2 kits.
Automatic Transmissions require 1 kit.
These bushings replace the stock pieces with precision machined Delrin to eliminate all the stop in your shifter. The kit comes with 4 bushings, and new cotter pins. Click the link to see an install video and to purchase.
These short shifters are a direct swap for your CB7 Accord (1990 - 1997) and 4th gen Prelude (1990 - 1993). They consist of Billet Aluminum and Stainless Steel construction and feature fully adjustable height, throw, and positioning. A great way to shorten shifts and better position the shifter on your Drag, Rally, Road Race, or Street Car. Single Bend Style.
These short shifters are a direct swap for your CB7 Accord (1990 - 1997) and 4th gen Prelude (1990 - 1993). They consist of Billet Aluminum and Stainless Steel construction and feature fully adjustable height, throw, and positioning. A great way to shorten shifts and better position the shifter on your Drag, Rally, Road Race, or Street Car. Dual Bend Style.
These short shifters are made of Stainless Steel, designed to shorten the throw in your Honda or Acura. Fully adjustable bottom and Delrin Bushings for an ultra smooth tight feel. Adjust from short to wrist flick shifts in less than 10 minutes. Machined to match stock shift knobs, match with a Cheddas Auto Billet knob for best fit.
Poly machined rear strut bushings replace the stock rubber ones for a stiffer feel. Kits come with 4 bushings (2 sets). Engraved with the Cheddas Auto logo.
Stamped steel control arms don't only look cheap they also feel cheap with poor rubber bushings making suspension geometry sloppy. Replace those outdated, loose, and possibly rusty control arms with 6061 Billet Aluminum. Cheddas Auto now supplies another chassis with great control arms. These arms are machined in house, and fitted with Energy Suspension bushings for the best feel and fluidity.
Machined from Billet 6061, anodized then engraved with either your choice of the Cheddas Auto "CA" logo or the RPR "Three Flags" logo. Comes in optional colors. Shipments to be made approx mid September. Featuring a MR5 styling, 5 sided, matching bolt pattern of the original MR5 Wheel.